Blowguns Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
180 Posts
To fix the sagging in pvc, heat up a 6in section of 3/4in pvc (for 1/2in) over the stove or heat gun until it is soft and pliable. Quickly slide the 3/4 in piece over the 1/2in until it is in the middle....this should fix the sagging

watch here
 

·
Registered
Joined
·
180 Posts
rather than using a bigger dia. piece of PVC pipe and working a way to support the PVC-BG... I took a straight connector piece that was made for that dia. ( they sell them to connect two pipes together)...

LGD
the point is not to have any joins in the pipe....even the slightest change in the smoothness of the inside of the pipe slows down the dart velocity. with the 3/4 pvc there is no creases or lips inside the tube....you can also choose the length of support you want
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top