Blowguns Forum banner

Here is a simple little mod ...

8194 Views 10 Replies 8 Participants Last post by  Chips
Taking the pipes out into the cold the other day to do some target practice, found the aluminum getting very

cold even with a guy like me who's told is full of hot air.

Here is a simple mod you can do to your home made jobbies that is in keepiing with this!

I grabbed at the local hardeware store some 1/2 inch pipe foam insulation. It also comes in 3/4 inch for your

bigger calibers. $.69 for a 4 ft piece!

All is needed is a sharp knife, some electrical tape, slide it on, get it in the right spot for you, and tape it down.

Very comfortable, and it will keep the cold pipes from seeping through to your hands when out in the field.




See less See more
  • Like
Reactions: 3
1 - 11 of 11 Posts
Thanks buddy, appreciate it. :)
Good one Turtle. I actually have some on hand.
I bet you can stab some darts into that material as a make shift quiver.
Thanks guys.

Ya it might work quite well as quiver material, might have to try
it out.
Multi-multi purpose.... loving this, thanks Turtle
Multi-multi purpose.... loving this, thanks Turtle
My pleasure.
1 - 11 of 11 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.